The Hurricane Forum
The Hurricane Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Hurricane for AutoCAD
 General Discussion
 Stuck at open, asks to save changes to the file
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

GregD
Starting Member

USA
3 Posts

Posted - May 10 2010 :  12:48:29 PM  Show Profile  Visit GregD's Homepage  Reply with Quote
I've just built up a new laptop and I'm having a problem I've not seen with Hurrcan before.
When ACAD launches, I'm asked if I want to discard changes Y/N.
I can type resume and the script runs on, but what setting is different from my old setup to make this happen?
Thanks,
GD

GeeDee

Admin
Administrator



631 Posts

Posted - May 10 2010 :  3:13:28 PM  Show Profile  Visit Admin's Homepage  Reply with Quote
Double check your "Tools->Options->Prefs->To Load Drawings" settings..

If you don't have it set to "Use Open with DBMod" and you have some PREUSERSCRIPT settings invoked, then it will prompt you for that.

Regards,
Bill

Hurricane for AutoCAD
http://www.74mph.com
FAQ at
http://www.74mph.com/faq/faq.html
Tutorials at
http://www.74mph.com/tutorials.html
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
The Hurricane Forum © 2009 - 2021 Go To Top Of Page
This page was generated in 0.08 seconds. Snitz Forums 2000